A CNC Cabinet Cooler that Runs Off Only Compressed Air

A CNC cabinet cooler that runs on only compressed air. A cabinet cooler uses a vortex tube to to convert compressed air into cold air. Since a vortex tube has no moving parts there is little maintenance involved with this system. A cabinet cooler can save you money over a normal cooling system, since it is run directly off of compressed air. Our cabinet cooler has a five-micron filter system which means that the air is always clean and dry before it is introduced to the sensitive controls. There are no moving parts so you can install the CNC Cooler and forget about heat related shutdowns. There are relief valves and seals built into the CNC Cooler which enables the unit to maintain the sealed nature of NEMA boxes.

A Cabinet Cooler That Uses a Vortex Tube For Inexpensive and Reliable Cooling

Our cabinet cooler includes a ducting kit for the cold air, which allows you to direct the cold air to the heat source in your control cabinet. Our cabinet cooler includes an adjustable electrically operated thermostat, a solenoid valve to provide thermostatic control for your systems, and installation instructions. The CNC cabinet cooler mounts into a standard 3/4" electrical knockout and the thermostat mounts into a standard 1/2" electrical knockout.

Install a Cabinet Cooler
and Stop CNC Control
Downtime Due to Heat,
Moisture, and Dirt while
Maintaining NEMA Ratings
at the Same Time

cabinet cooler pic

USED TO COOL

  • CNC CONTROLS
  • PLC'S
  • MOTOR CONTROLS
  • INDUSTRIAL CAMERAS

FEATURES

  • COMPACT
  • NO FREON
  • THERMOSTATICALLY CONTROLLED
  • NO MOVING PARTS
  • NO FANS OR FILTERS

BENEFITS

  • LOW COST
  • RELIABLE
  • EASY INSTALLATION
  • STAINLESS STEEL CONSTRUCTION
  • NO MAINTENANCE
  • NO VIBRATION - QUIET

cabinet cooler img1
DIRECT TO YOU!     CALL FREE --- 1-800-660-4060
VORTEX CNC COOLERS
A/C FOR CNC CONTROLS WITHOUT FREON-ELECTRICITY-OR MOVING PARTS
STAINLESS STEEL CONSTRUCTION

cabinet cooler img2